FALMEC LEVAN120W, Инструкция пользователя

Страница: 14 / 84

14
• fixed equipment not provided with a power supply cable and plug, or any
other device that ensures disconnection from the electrical mains, with an
opening gap of the contacts that enables total disconnection in overvoltage
category III conditions.
Said disconnection devices must be provided in the mains power supply in
compliance with installation regulations.
The yellow/green earth cable must not be cut off by the switch.
The Manufacturer declines all responsibility for failure to comply with the safety
regulations.
FUMES DISCHARGE
HOOD WITH INTERNAL RECIRCULATION (FILTERING)
In this model, the air passes through the zeolite-carbon filters
to be purified and recycled in the environment.
Ensure that the active carbon filters are assembled into the
hood, if not, install them as indicated in the assembly instruc-
tions.
In this version the check valve must not be assembled: remove it if it is
on the air outlet fitting of the motor.
ASSEMBLY INSTRUCTIONS
only intended for qualified personnel
The hood can be installed in various configurations.
The generic assembly steps apply to all installations; for each case,
follow the specific steps provided for the required installation.
OPERATION
WHEN TO TURN ON THE HOOD?
Switch on the hood at least one minute before starting to cook to direct fumes
and vapours towards the suction surface.
After cooking, leave the hood operating until complete extraction of all vapours
and odours. By means of the Timer function, it is possible to set auto switch-off
function which will allow the hood to turn off automatically after 15 minutes of
operation.
WHICH SPEED IS TO BE SELECTED?
1st speed: maintains the circulation of clean air with low electricity consump-
tion.
2nd speed: normal conditions of use.
3rd speed: presence of strong odours and vapours.
4th speed:
rapid disposal of odours and vapours.
WHEN SHOULD THE FILTERS BE WASHED OR REPLACED?
The metal filters must be cleaned every 30 hours of operation.
The zeolite-carbon filters must be reactivated every 18 months and replaced
every 3 years.
For further details see the
“MAINTENANCE”
chap.
ELECTRONIC PUSHBUTTON PANEL
Brief
pressure
Motor ON/OFF
Brief
pressure
Increase speed
from 1 to 4
Speed 4 is only
active for a few
minutes, then
speed 3 activa-
tes.
The speeds are indicated by the
LEDs on the keys:
Speed 1
Speed 2
Speed 3
Speed 4
("+" LED flashing)
Brief
pressure
Reduce speed
from 4 to 1
Prolonged
pressure
Lifting the hood
Activated only with the fan not working.
Stop:
- when the upper microswitch is reached
- pressing the + or - button.
Prolonged
pressure
Lowering the hood
Activated only with the fan not working.
Stop:
- when the lower microswitch is reached
- pressing the + or - button.
Brief
pressure
Light on/off
Prolonged
pressure
Change light tone from 2700K to 5600K
Brief
pressure
TIMER
Auto switch-off after 15 min.
The function deactivates (red LED off ) if:
- The TIMER key ( ) is pressed again.
- The ON/OFF key ( ) is pressed.
If the pushbutton panel is completely inactive, before contacting
the Technical assistance service, disconnect power temporarily to
the appliance (about 5“), possibly by acting on the main switch, to
restore normal operation.
If this measure has no effect, contact the Technical assistance service.
HOOD MOVEMENT SETUP
Press button for 10 se-
conds
When SETUP is started, all LEDs light up
The hood moves slowly
upwards until it reaches the
upper limit switch
The hood moves downwards
until it reaches the lower li-
mit switch.
If you want to set the hood
stop before it reaches the
lower limit switch, which
represents the maximum
lowering, press + or - on the
button panel or or or