17.
Remove the (4) batteries from the left side Bay 1. Next remove the (4) batteries from
the left side Bay 2. Finally, remove the (4) batteries from the left side Bay 3. Now
install (4) new batteries ( with the terminals up) into Bay 3. Install (4) more new
batteries (with the terminals up) into the left side Bay 2. Install the final (4) new
batteries
(WITH THE TERMINALS OUTWARD)
into the left side Bay 1.
USE CARE
NOT TO SHORT THE BATTERY TERMINALS TO THE CHASSIS METAL PARTS.
18.
Reinstall (2) of the left side battery hold down brackets over the batteries on
Bays 2 & 3 and secure with the screws removed in step 10.
19.
Reinstall (3) small battery jumpers between BATT17 positive to BATT18 negative,
BATT18 positive to BATT19 negative and BATT 19 positive to BATT20 negative. Next,
reinstall the RED (B) wire to the BATT20 positive terminal. Reinstall the black jumper
to the BATT17 negative terminal. You may have to slide the batteries out sleightly to
get at the terminals to reinstall the wiring.
20.
Reinstall the (1) remaining battery hold down bracket over the batteries located on the
left side Bay 1 and secure with the remaining screw removed in step 10.
21.
Reinstall the (6) small jumpers between BATT9 positive to BATT10 negative,
BATT10 positive to BATT11 negative, BATT11 positive to BATT12 negative,
BATT13 positive to BATT14 negative, BATT14 positive to BATT15 negative,
BATT15 positive to BATT16 negative.
22.
Reinstall (1) of the long jumpers removed in step 13 from BATT13 negative to
the BATT12 positive terminal. Now reconnect the black wire coming from the right
side BATT8 positive, to the BATT13 negative terminal. Connect the black jumper
connected to the BATT17 negative terminal to the BATT16 positive terminal. The left
side battery wiring is now complete go to the next step.
23.
Reinstall the (6) small battery jumpers between BATT5 positive to BATT6 negative,
BATT6 positive to BATT7 negative, BATT7 positive to BATT8 negative,
BATT1 positive to BATT2 negative, BATT2 positive to BATT3 negative, and
BATT3 positive to BATT4 negative.
24.
Reinstall (1) of the remaining long jumpers removed in step 13 to the BATT5 negative
terminal and the other end to the BATT4 positive terminal. Now reconnect the black
wire coming from the Battery Circuit Breaker to the BATT1 negative terminal.
DO NOT RECONNECT THE RED WIRE TO THE BATT20 POSITIVE TERMINAL
AT THIS TIME AS UPS DAMAGE MAY RESULT.
25.
Using a voltmeter set to the 300Vdc scale, place the positive (red) lead on BATT1
negative (BLACK) terminal and the positive (RED) terminal on the BATT20 positive
terminal. The meter should read 235 - 276Vdc. If you do not get the correct voltage
reading recheck steps 18-24.
DO NOT PROCEED UNTIL THE CORRECT METER
READING IS OBTAINED.
26.
Reconnect the RED wire coming from the main circuit board loBATT to the
BATT20 positive terminal.
7
