Falcon SG1.5K-1T, Руководство по эксплуатации для владельца

Страница: 4 / 27

IMPORTANT SAFETY INSTRUCTIONS
SAVE THESE INSTRUCTIONS
This manual contains important instructions which must be followed during the installation,
operation and maintenance of this UPS and its batteries. Please read all instructions before
operating this equipment and save this manual for future reference.
All of the models presented herein are designed for installation and use in a temperature-controlled
environment, free of contamination.
This UPS utilizes voltage that may be hazardous. Do not attempt to disassemble. This unit contains no user
replaceable parts.
Refer all servicing to Falcon Electric, Inc.
THIS UPS IS NOT INTENDED TO BE USED IN CONJUNCTION WITH LIFE SUPPORT OR OPERATING
ROOM EQUIPMENT.
Always unplug this UPS and remove the UPS battery fuse prior to cleaning and never apply liquid or spray
detergent on the UPS.
Never attempt to service batteries . High voltage exists within the unit, which could cause electrical shock.
Servicing of batteries should be performed or supervised by personnel knowledgeable of batteries and the
required precautions. Keep unauthorized personnel away from batteries. When replacing the UPS batteries,
use the same number and type of batteries.
Allow at least 24 hours, after the UPS is first installed and turned on, to fully charge the internal battery and
assure the maximum backup time is available.
DO NOT plug this UPS into its own output as this may damage the UPS. The maximum UPS output load
(in watts) must never exceed that shown on the UPS rating label. NEVER CONNECT equipment that could
overload the UPS or demand half-wave rectification from the UPS, for example: electric drills, vacuum
cleaners or hair dryers. Never connect surge protected plug strips to the UPS output.
NEVER CONNECT equipment that could overload the UPS or demand half-wave rectification from the UPS,
for example: electric drills, vacuum cleaners or hair dryers. Never connect surge protected plug strips to the
UPS output.
DO NOT remove or unplug the input cord when the UPS is turned on. This removes the safety ground from
the UPS and the equipment connected to the UPS.
This UPS contains its own energy source (batteries). The output receptacles may carry live voltage
even when the UPS is not connected to an AC source.
CAUTION
CAUTION
CAUTION
CAUTION
CAUTION
IMPORTANT
DO NOT
CAUTION
CAUTION
IMPORTANT
2