CHAPTER 2
CHAPTER 2
Installation
Inspecting the Equipment
If any FALCON
®
equipment has been damaged during shipment, keep
the shipping cartons and packing materials for the carrier and file a
claim for shipping damage. If you discover damage after acceptance,
file a claim for concealed damage.
To file a claim for shipping damage or concealed damage: 1) File with
the carrier within 15 days of receipt of the equipment; 2) Send a copy
of the damage claim within 15 days to the Falcon
®
Service Department.
UPS & Sensaphone 1104 Setup
1.
Verify that the following is included in the UPS shipping carton:
UPS, Input line cord, RS-232 software, Owner's Guide.
2.
Verify that the UPS unit is configured for the proper input/output
voltage. This information is stated on the nameplate label located on
the rear panel of the unit.
3.
Verify that the following is included in the Sensaphone shipping carton:
Sensaphone 1104 with connected UPS interface cable, Power Supply,
IEC320 to NEMA 5-15R adapter cable, User’s Manual and X10
Manual.
4.
Install the six “D” cell batteries into the Sensaphone unit. Refer to the
Sensaphone user’s manual for details.
4.
Select a suitable location for the UPS and Sensaphone unit, near
enough to the computer or equipment to be protected and monitored to
allow connection of the equipment power plug(s) to the receptacles
located on the rear panel of the UPS.
5.
DO NOT BLOCK UPS AIR VENTS. THE UPS MUST NOT BE
INSTALLED IN AN ENCLOSED AREA.
6.
Refer to the SG UPS Rear Panel Detail on the next page for the
following steps.
a.
Connect the Sensaphone input power to UPS outlet 4
using the supplied IEC320 to NEMA 5-15P adapter
cable.
b.
Connect the DB-9 MALE connector on the Sensaphone
interface cable to the Sensaphone A Port on the UPS rear
panel.
c.
Connect the DB-9 FEMALE connector on the
Sensaphone interface cable to the Sensaphone B Port on
the UPS rear panel.
