
2.5 TURNING THE BURNER OFF
Refer to Figure 2. Proceed as follows:-
For Short Periods
To turn off burner leaving pilot lit, push in knob and turn it
clockwise to pilot position.
For Long Periods e.g. Overnight
To turn off burner and pilot, push in knob and turn
clockwise to OFF position.
Note
Every turn of the tap has to be preceded by control being
pushed in.
Safety Precautions
A stopcock must be fitted in pipe which supplies gas to
appliance. The user must be familiar with the location and
operation of this to enable gas to be turned OFF in an
emergency.
2.4.2 G2625, G2925, G21225, G21525 Models
Piezo Ignition
a) Push tap in and turn anti-clockwise to pilot position.
b) Hold tap fully in and press igniter button.
c) Observe, through the slots, that pilot is lit.
d) If not, press ignition button repeatedly until pilot does
light.
e) When pilot is lit, continue to hold tap fully in for
20 seconds before release. If pilot goes out, wait
3 minutes and repeat from
(b)
.
f) Repeat for remaining burners using other ports and
respective gas taps.
If piezo igniter is non-functional, then back up ignition is
achieved by manual ignition
(See 2.4.1)
.
Figure 2 - Control Knob Details
2.4.3 Lighting of Main Burner
a) When pilot is established, push tap in and turn
anti-clockwise to HIGH position
(large symbol)
to light
burner.
b) The tap can be adjusted between HIGH and LOW
depending upon requirements.
If a burner extinguishes intentionally or otherwise,
NO ATTEMPT to re-light it should be made until at least
3 minutes have elapsed.