mbar
inches w.g.
NATURAL
15
6
PROPANE
37
14.8
NATURAL PROPANE
Main Burner 2.05mm
Amal 210
Pilot Burner SIT No.30 SIT No.19
1.8 INJECTOR DIAMETERS -
Natural and Propane Gas
1.9 SETTING PRESSURE
A spring loaded governor, supplied with the appliance
MUST BE FITTED tonatural gas models.
No governor is required on propane models.
A pressure test point is accessible upon removal of
the control panel.
1.10 BURNER ADJUSTMENT
Burner Aeration
The burners are fitted with fixed injectors. The
aeration is adjustable by means of a screw which
is positioned at the burner inlet.
After setting the pressure, the stability of the cones
should be checked. If necessary, the aeration screw
should be adjusted to achieve satisfactory cross
lighting of the burners on both HIGH and LOW
settings. This will also prevent yellow tipping of the
flame or lift-off.
SECTION 2 - ASSEMBLY and
COMMISSIONING
2.1 ASSEMBLY
2.1.1 Grill Unit
Unpack the grill and check that all components are
undamaged. Parts supplied loose are specified in the
contents list below
Brander Drip Trough
Brander Plate
Grid Shelf
Drip Tray
Gas Governor (Natural Gas only)
Additionally, 6 refractory plaques, 4 centre support
bars of double construction and 4 end support bars.
Appliance Mounting Accessories
Details of the various grill mounting options are
detailed in section 1.1.
Individual Check Lists for Mounting Options
Bench Legs
Pack contains -
4 legs and screw pack in polythene bag.
2.1.2 Bench Legs Assembly
Bench legs when supplied, must be fitted tothe
underside of the grill using the screws and washers
provided (see Figure 1). It is recommended that the
legs be fitted at the start of assembly and that the
operation is facilitated by placing the grill on its back.
Each foot is secureded by two fixings. Use Holes 1
and 3 as indicated in each sketch.
The leg locating brackets are then secured to the
worktop surface using woodscrews or bolts as
appropriate. The fixing hole centres are indicated in
the diagram above. The brackets should be rotated to
ensure that the threaded hole corresponds with the
side fixing hole in each leg.
The grill is then lifted intothe brackets up inside the
tubular legs. Each leg is then secured toa respective
bracket using the fixings provided.
Figure 1
