Falcon E9241, Инструкция для пользователя, по установке и обслуживанию

Страница: 16 / 31

11
6.3 ELECTRIC SUPPLY & CONNECTION
6.3.1 The location of the electrical inlet is as seen in section 5.0. This unit is suitable for AC
supplies only. The standard terminal arrangement is Three phase (400V 3N~) for all
variants.
6.3.2 A suitable supply cord is supplied that conforms to code designation 60245 IEC 57,
cable specification H07RN-F 5G2.5 or (H07RN-F 3G6 for single phase appliance).This
appliance is designed to, and must, be connected to fixed wiring. If cord is damaged, it
must be replaced by a suitably qualified person. Access to mains terminal block is
gained by removing control panel. (See 7.3).
Live 1 ( Phase 1) Brown
Live 2 ( Phase 2) Black
Live 3 ( Phase 3) Grey
Neutral Blue
Earth Yellow/Green
Live (Single Phase) Brown
Neutral Blue
Earth Yellow/Green
THIS APPLIANCE MUST BE EARTHED
6.4 COMMISSIONING
6.4.1 Open door ensuring drain valve is closed.
6.4.2 Ensure element is in the horizontal position.
6.4.3 Fill pan with water to maximum level mark.
6.4.4 Switch on unit.
6.4.5 Adjust operating thermostat to desired temperature.
6.4.6 If the appliance does not operate correctly please refer to section 9.0 and rectify the
problem.
This appliance is also provided with a terminal for connection of an
external equipotential conductor. This terminal is an effective electrical
contact with all fixed exposed metal parts of the appliance, and shall
allow the connection of conductor having a nominal cross-section area
of up to 10mm². It is located at the rear of the unit and identified by the
following label and must only be used for bonding purposes.