Falcon E711, Инструкции по установке и обслуживанию, Страница: 4 / 7

3.4 TO REMOVE ELEMENT
a) Remove back panel as Section 3.2.
b) Remove back baffle as Section 3.3.
c) Undo element connections via rear of unit.
d) Remove fixing screws.
e) Withdraw element.
f) Replace in reverse order ensuring earth tab is
connected properly.
3.5 TO REMOVE FAN
a) Remove back panel as Section 3.2.
b) Remove back baffle as Section 3.3.
c) Undo fan connections.
d) Remove earth connection.
e) Undo impeller retaining nut (LH thread) and remove
impeller.
f) Undo 4 fixings that secure motor mounting plate to
oven rear panel and remove screws.
e) Replace in reverse order, ensuring rear of impeller is
10mm from oven rear.
3.6 TO REMOVE NEON INDICATOR
a) Remove control panel as Section 3.1.
b) Remove connections.
c) Remove securing nut and withdraw neon.
d) Replace in reverse order.
3.7 TO REMOVE OVEN THERMOSTAT
a) Remove control panel as Section 3.1.
b) Remove control knob.
c) Remove connections, noting positions.
d) Undo fixings that secure thermostat to control panel.
e) From inside of oven, remove phial guard located at top
RH side.
g) Feed phial back through oven side hole.
h) Remove phial sleeving.
i ) Replace in reverse order.
3.8 TO REMOVE TIMER
a) Remove control panel as Section 3.1.
b) Remove control knob.
c) Remove connections, noting positions.
d) Undo fixings securing timer to control panel.
e) Replace in reverse order.
3.9 TO REMOVE HIGH TEMPERATURE LIMIT DEVICE
a) Remove control panel as Section 3.1.
b) Remove connections, noting positions.
c) Undo fixings that secure device to base panel.
d) From inside oven, remove phial guard located at top
RH side of unit.
e) Feed phial back through oven side hole.
f) Replace in reverse order.
3.10 TO REMOVE POWER INPUT CABLE
a) Remove rear panel as Section 3.2.
b) Slacken cable securing clamp.
c) Undo terminal block and earth fixings.
d) Replace in reverse order. Replace plug and cable type
as detailed in Section 1.3. Ensure cable is fed through
clamp and pulled tight before clamp is secured.
3.11 TO REMOVE BUZZER
a) Remove control panel as Section 3.1.
b) Remove connections, noting positions.
c) Remove fixing that secures buzzer to base.
d) Replace in reverse order.
3.12 TO REPLACE DOOR SEAL
a) Unclip seal from front frame.
3.13 TO REPLACE DOOR CATCH
a) Drill out pop rivets that secure inner and outer door
panels, taking care with glass panels.
b) Drill out pop rivets that secure catch.
c) Replace in reverse order.
3.14 TO REPLACE DOOR STUD
a) Unlock nut and remove stud.
b) Replace stud to ensure a tight seal prior to tightening
nut.