If the monitor shows a blue screen, still picture or fuzziness the battery may be weak or the camera
may be out of range.
3. Charging the battery
To charge your camera pull the orange cover on the rear of the camera to reveal the charging socket
and plug the charge lead in.
Connect the other end of the charge lead to the included USB to car cigarette lighter/accessory
socket adapter or a USB mobile phone adapter.
The camera should reach a full charge from flat in approximately 4.5 hours.
The LED on the camera is red when the camera is charging and switches off when the camera is fully
charged.
After charging be sure to refit the orange rubber cover to the charge socket to prevent water
ingress.
4. Pairing the camera and monitor.
The system comes already paired so you should not need to pair them unless replacing the monitor
or camera.
Pairing:
1. Turn the camera on by pressing the power button for 2 seconds.
2. Hold the power button on the camera for 6 seconds until the LED flashes Blue, the camera is
now in pair mode for 10 seconds.
3. Turn on the monitor by pressing the power button for 3 seconds.
4. Push the paid button on the monitor until PAIR OK is displayed.
5. Turn the monitor off my pressing the power button for 3 seconds and then turn it back on.
The system is now paired.
