Falcon 1200 Mercury Induction, Руководство пользователя и инструкции по установке

Страница: 21 / 48

17
English
15 mm
Approx.
Make sure the inner
rail is pulled forwards
To Remove and Fit a Shelf to the Side Supports
The shelf has a small kink on either side (Fig.2.23) . To remove
the shelf, line these up with the stops in the shelf support
(Fig.2.24) . Lift the rear of the shelf upward so that it will pass
over the shelf stop and then pull it forward (Fig.2.25) .
Fit in the reverse order, making sure to push it fully back.
To Remove and Refit the Ladder Shelf Supports
Lift the ladder support hooks out of the two locating holes in
the oven side (or divider) before lifting the support clear of
the bottom ladder restraint.
Refit by inserting the bottom of the ladder into the restraint
before fitting the hooks through the locating holes.
Storage
The bottom drawer is for storing oven trays and other
cooking utensils.
To open, simply push the drawer in and release.
It can get very warm, so do not store anything in it that may
melt or catch fire. Never store flammable materials in the
drawer. This includes paper, plastic and cloth items, such as
cookbooks, plastic ware and towels, as well as flammable
liquids. Do not store explosives, such as aerosol cans, on or
near the appliance.
n
Flammable materials may explode and result in fire
or property damage.
The drawer can be removed completely for cleaning, etc.
To Remove the Storage Drawer
To open, simply push the drawer and release. The drawer will
open.
Push the ends of the plastic clips – down on the left-hand
side, up on the right-hand side – to release the catches
holding the drawer to the side rails
(Fig.2.26)
. At the same
time pull the drawer forwards and away from the side rails.
For safety reasons slide the inner side rails back into the
cavity.
To Fit the Storage Drawer
Slide the inner side rails out until fully extended
(Fig.2.27)
.
Lift the drawer at its sides and locate one of the drawer rails
(approximately 15 mm) onto an inner side rail (Fig.2.28) .
Rotate the drawer to locate the remaining drawer rail onto
the opposite inner side rail.
Carefully slide the drawer back into the cavity. Some
resistance will be felt as the drawer rails locate fully onto the
inner side rails.
Fig.2.24 Fig.2.25
Fig.2.26
Fig.2.27
Fig.2.28