FALCOM MAMBOII, Руководство пользователя

Страница: 200 / 271

C
ONFIGURATION
C
OMMAND
S
ET
- F
IRMWARE
R
EVISION
2.4.0_
BETA
- V
ERSION
1.0.0
For our example:
“ GPS.Geofence.e1=outside ”
and
“ GPS.AREA.e4=outside ”
events occur when the Latitude of
the unit’s current position is bigger than
10°57’17”
AND smaller than
10°53’11”
AND
the Longitude of the vehicle’s current position is bigger than
50°42’41”
AND
smaller than
50°40’16”
.
“ GPS.Geofence.e1=inside ”
and
“ GPS.AREA.e4=inside ”
events occur when the Latitude of
the unit’s current position is smaller than
10°57’17”
AND bigger than
10°53’11”
AND
the Longitude of the vehicle’s current position is smaller than
50°42’41”
AND
bigger than
50°40’16”
.
 After the user has set up a Geofence zone into the MAMBOII device, it starts comparing
the current location with the location geofence zone. If there is any disagreement to the
configuration, MAMBOII will send notification via SMS or TCP packet etc. (including alarm
information) depending on the configuration.
3.2.24.3 GF.CONFIG
Parameter syntax GF.CONFIG= maxdop = <m_value>, parkradius = <p_value>, changes = <c_value>
This parameter manages the global configuration of the Geofence functionalities.
Based on this configuration all events occurred within Geofence range are
controlled.
<m_value>
It specifies the allowed maximal PDOP (GPS position accuracy error) value, in
meter, for Geofence management solution. Solution is reported If the set PDOP
value is exceeded, no Geofence events occur. The word “
maxdop
” is
predefined.
<p_value>
It defines the radius in meter of the circular area to be used as Geofence park
area. Center point is the MAMBOII position. It places the MAMBOII (vehicle) into
a restricted circle zone (park radius), where the current position (including
Latitude and Longitude) of the MAMBOII is the center of circle and the “
value ”
is the radius of circle. The word “
parkradius
” is predefined.
<c_value>
It defines whether or not the Geofence (
GF.e<ID>
) events will be
occurred/enabled. The word “
changes
” is predefined, while its value can be
set/changed to:
Value Meaning
on
Enables Geofence events occurring (
GF.e<ID>
).
AREA
events always will be occurred
)
off
Disables Geofence events occurring (
GF.e<ID>
). (
AREA
events always will be occurred
)
.
How to set/get GF configuration:
Set configuration
$PFAL,Cnf.Set,GF.CONFIG=maxdop=5,parkradius=200,changes=on
Get configuration
$PFAL,Cnf.Get,GF.CONFIG
This confidential document is a property of FALCOM and may not be copied or circulated without previous permission.
Page 200 of 271