Falco FAL-35-IRS, Инструкция по эксплуатации

Страница: 7 / 11

6

Before installation and usage, read all the instructions and make sure that the voltage (V) and
the frequency (Hz) indicated on your cooker hood are exactly the same as the voltage (V) and
the frequency (Hz) in your home.

In order to get the most out of your cooker hood, please read the instruction manual before
installing & using, and keep it in a safe place.

Contact you local government for information regarding the collection systems available

If electrical appliances are disposed of in landfills or dumps, hazardous substances can leak
into the groundwater and get into the food chain, damaging your health and well-being.

Children should be supervised to ensure that they do not play with the appliance.

Regulations concerning the discharge of air have to be fulfilled.

CAUTION: Accessible parts may become hot when used with cooking appliances.

Attention! Observe the warning in the instruction sheet concerning the operation of the
appliance when air is discharged from the room.
4. INSTALLATION INSTRUCTIONS
1. The cooker hood must placed at a distance of 65-75cm from the
surface for the best effect. See Pic 1.
2. For safety, the ceiling should be bear at least 120kgs, and the
thickness should be more than 30mm. Drill a hole on the position for
cooker hood with
Φ
170mm on the ceiling
3. According to the hanging board, drill 9 holes on the ceiling. Use 9
pcs ST6X40mm screws to fix the hanging board on the wooden
ceiling or use 6 pcs concrete anchor to fix the hanging board
on
.
concrete ceiling. See Pic 2.
4. Calculate the length of angle bar according to Pic 1
。
To connect the
angle bar and bracket with 18 pcs M4X10 screws ,M4 nut and
washer. (the overlap between angle bars should more than 100mm)
See pic 3
.
5. Using 6 pcs M4X10 screws to fix the angle bars on the cooker hood housing, and install the
extensible pipe. See pic 4/5. Set the inner chimney
6. Put fixation of angle bars on the three installed angel bars. And then using 6 pcs M4X10
screws, M4 nut and washer to fix. See Pic 6
7. See Pic 7, put the inner chimney on the cooker hood housing.
8. See Pic 8, put up the unit, and take the extensible pipe out of ceiling. And then using 6 pcs
M4X10 screws, M4 nut and washer fix the angle bar of unit to the hanging board.
9. See Pic 9. Undrawn the inner chimney and use 3 pcs ST4X8 screws to fix the inner chimney
on hanging board.