Fakir VEZUV, Инструкция по эксплуатации

Страница: 20 / 24

20
TROUBLESHOOTING GB
Fault
Iron emits an
odor or smoke
Iron does not
heat
Iron does not
steam
Burst of steam
feature does
not work
Spry mist
feature does
not work
Iron is leaking
Possible cause
Iron gives off an odor when
turned on for the first time.
The temperature dial did not set
at the desired temperature.
The water tank many be empty.
The water tank can be empty
and temperature button set to
shouldn’t steam.
The water tank must be at least
1/4 full.
Temperature should be set to
low level.
Solution
Oils used during manufacture need to
be burnt off allow ten minutes for odor
to disappear.
The iron should be plugged into a 230
Volt , AC electrical outlet only. The
temperature dial must be set at the
desired temperature.
Turn the steam valve to “ ” and add
water .Allow the iron to heat, and then
set the steam dial to the steam setting.
The water tank must be at least 1/4 full.
Temperature must be set to steam
position. Iron should be in the
horizontal position. Prime pump briefly.
Allow a short pause between shots. Be
sure to fully depress the burst of steam
button.
Fill the iron as described in the section
“how to fill the water tank”.
The variable steam dial must be set on”
“,until the iron is hot. The temperature
setting is too low to produce steam.
Shot of steam used too much, allow
iron to re-heat.