Starky I HSA
GB
28
1) Press the dust collection tank
release button to remove the dust
collection tank.
2) Take out the cyclon-type filter
and the filtering cotton frame.
3) Empty the dust container into a
garbage container and freeing
the filter insert with cyclone filter
and filter frame from dirt and
debris.
4) Take out the filtering cotton and
separate the filtering cotton.
Press while the “PUSH” button.
Use a brush to clean it. The foam
filter you can wash and after
completely dried install those into
the filtering cotton.
5) Now connect the filter frame with
the filter insert back until it clicks.
6) After taken out the motor protec-
tion filter, wash the foam by water
and install it back to the appli-
ance after is it completely dried.
Cleaning.and replacement of the
electric suction brush
If the brush is worn or stuck, it
should be cleaned or replaced
(only with components with the
same specification) to make sure
the brush can smoothly operate
and ensure the safety; the rotation
shaft of the electrical soft roller
brush tends to be stuck by cotton
fibers, hairs and the like, so the
rotation shaft should be kept
cleaned.
1) Press the brush release button
to take out the brush (left bottom
figure), and use a flathead screw-
driver to left rotate the small
cover at the left bottom of the
brush (right bottom figure); then,
use the screwdriver to remove
the dust and hairs or use your
fingers to pull the edge of the soft
brush to remove the dust and
hairs.
2) If there are matted cotton fibers
or hairs, use a scissor to cut
them and clean the rotation shaft
to make sure the rotation shaft
can rotate smoothly; after the
rotation shaft is cleaned, please
install the rotation shaft back to
the appliance by reverse pro-
cess.
Brush release
button