Fakir DRYWELL, Инструкция по эксплуатации

Страница: 22 / 56

22
EN
USAGE
Operation of key pads 1. When plug into power socket, 2 beep signals can be
heard.
2. Press the “ON/OFF” button to turn on the unit. The
deflector startup automatically and the unit is in the
status of constant dehumidifying and high speed
running.
a
）
The blue backlight will illuminate and turn off after 15
second.
b
）
The LCD display shows the working mode and status of
unit.
c
）
The LCD display shows the ambient humidity and
temperature).
d) Press the “ON/OFF” button again, the unit will stop
working and the deflector close.
3. Press MODE: Set up Continuous & Automatic
dehumidifying modes, Wind Speed. Select or change to
the desired mode, the indicator light will illuminate
correspondingly, then press “Setting” to change the
running mode and automatic dehumidifying ratio.
• When automatic dehumidification indicator
illuminates, press “Setting” to make it circulating among
60%RH-65%RH-70%RH-75%RH-80%RH-40%RH-45%
RH-50%RH-55%RH -60%RH·····
a
）
When entered into automatic dehumidification and press
“Setting”, the continuous dehumidifying mode will be
canceled.
b
）
Press “Mode” or three seconds after pressing “Setting”,
the desired humidity ratio is setted and the indicator light
stops to illuminate.
c
）
When sensor detected ambient humidity is 1% lower
than your setting, compressor shut off and fan works at
low speed. If ambient humidity is 5% higher than the
setting, the dehumidification is activated again.
• When the indicator light of wind speed illuminates,
press “Setting” to select the fan blower working at “High
speed” level or “Low speed” level.
a) It shows ‘L’ when working at “Low speed” level and
shows ‘H’ when working at “High speed” level.
b) Press “Mode” or three seconds after pressing “Setting”,
the wind speed is setted.
c) When the wind speed is setted, dynamic patterns rotate.
d) When sensor detected ambient humidity is lower than
your setting, fan works at low speed.
e) When sensor detected ambient temperature exceeds
32°C, it goes to the “High speed” level automatically.