5
EN
1. DESCRIPTION (Fig 1)
2. TECHNICAL DATA
A.
Air inlet grille
B. Air outlet grille
C. Thermostat control
D. Function selector dial
E. Pilot light
F. Cable compartment
G. Base
H. Wall support
Voltage - Frequency: 230V~50 Hz
Power
- Position 1: 1000W
- Position 2: 2000W
6. MAINTENANCE
Before carrying out any maintenance or
cleaning of the appliance, make sure it is
unplugged from the mains.
Regularly vacuum the air inlet and outlet
grilles to clean them.
Never use abrasive powders or solvents.
3. CONNECTION TO THE MAINS
• Before plugging the fan heater in, ensure
the domestic voltage is the same as that
indicated on the reference plate on the
underside of the appliance.
• Ensure the electrical socket has a
capacity of 10-16 amperes.
• This appliance complies with EEC
directive 89/336 regarding
electromagnetic compatibility.
4. INSTALLATION
This appliance is designed to work in
vertical position, either standing upright on
its base or fixed to the wall.
Mounting the base
To use the appliance standing on the floor,
mount it on its base so that it is stable and
will not fall over (fig. 1).
Wall mounting
• Take the wall support out of its housing
(Fig. 1).
• Fix the support to the wall, complying
with the minimum measurements
indicated in fig. 2.
• Hook the appliance onto the support.
5. FUNCTIONING AND USE
Important: This appliance is not
designed for use in damp or wet areas.
Do not install it in bathrooms or near
sinks, swimming pools, etc.
Switching the heater on
Plug the appliance in at the mains. Turn the
thermostat to "MAX".
Low power heating: turn the dial to 1 .
The pilot light will come on.
Full power heating:turn the dial to 2 . The
pilot light will come on.
Adjusting the thermostat:
When the room has reached the desired
temperature, slowly turn the function
selector dial clockwise until the pilot light
goes off or until you hear a click. The
temperature set in this way is automatically
regulated and maintained by the thermostat.
Summer use (fan only): turn the function
selector dial to
Switching the heater off
To switch off the appliance, turn the function
selector dial back to "O".
interior 19/4/04 12:07 Página 4
