Fagor Spoutnik, Инструкция по эксплуатации

Страница: 8 / 20

Installing your appliance EN
Worktop installation
Remove all packaging material and accessories. Examine the oven for any sign of transit damage, do not
continue if the appliance is damaged.
Turntable installation
a. Never place the glass tray upside down. The glass tray should never
be restricted or jammed.
b. Both the glass turntable and turntable ring must be used during
cooking.
c. All food receptacles / containers must always be placed on the glass
turntable prior to commencing cooking.
d. If the glass is broken please contact after-sales service for a replace-
ment prior to using the oven again. This is not covered under the
warranty
Positioning your appliance
Select a level surface that provides enough
space to allow the oven vents to be clear of
obstruction. A minimum of 10cm is required
between the oven and any adjacent wall, one
side should be fully open.
The oven should be positioned with at least
30cm clearance above it, this allows the cover
to be opened without obstruction and steam
to vent out.
Allow 15cm to the rear of the oven.
Blocking any air inlet / outlet can damage the
oven.
• Your installation must be protected by a 13 Amp fuse.
• It is mandatory to use a power point with an earth terminal, connected in accordance with current safety reg-
ulations.
• In your electrical installation, provide a device that is accessible to the installer, capable of separating the ap-
pliance from the main power and whose contact opening is at least 3 mm at all of the poles.
• If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified
persons in order to avoid hazard.
WARNING: Do not install oven over a hob or other heat-producing appliance. If installed near or over a heat
source, the oven could be damaged and the warranty would be void.
Electrical connection
8
4