Fagor LFI-046IT, Инструкция по эксплуатации

Страница: 22 / 29

20
Tension adjustment
of the door spring
【Figure5】
Tension adjustment of the door spring
●
Connection of drain hoses
●
The door springs are set at the factory to the proper tension for the outer door. If aesthetic
wooden panel are installed, you will have to adjust the door spring tension. Rotate the adjusting
screw to drive the adjustor to strain or relax the steel cable(see figure 5).
Door spring tension is correct when
the door remains horizontal in the
fully opened position，yet rises
to a close with the slight lift of a
finger.
relax
Drain pipe connection
【Figure6】
φ
40mm
A
B
C
Co un ter
Fro nt
Drain pipe
Drain hose hook Close the drain hose hook to the counter
Insert the drain hose into a drain pipe with a minimum diameter of 4cm, or let it run into the sink,
making sure to avoid bending or crimping it. Use the speicalplastic support that comes with the
appliance (figure 6).
. ATTENTION: The special plastic hose support must be
solidly fastened to the wall to prevent the drain hose from moving and allowing water to spill
outside the drain.
The top of the hose must be at a height between 40 and 100cm.The free end
of the hose must not be immersed in water