Fagor FXM1 Series, Руководство по установке

Страница: 22 / 174

   General concepts
1.
GENERAL CONC
E
PTS
Mecha
nical
con
cepts
34
· 22 ·
Ref.2105
FXM|FKM
SERVOMOTOR
1.2 Mechanical concepts
Construction types
FXM/FKM motors, according to the nomenclature of the IEC 60034-7
directive, admit the following mounting methods. These motors are
supplied for flange mounting. They may be installed horizontally (IM B5)
or vertically with the shaft facing down (IM V1) or with the shaft facing up
(IM V3). See figure
F- 1/7 .
Degrees of protection
According to the IEC 60034-5 directive, all AC servomotors of Fagor
Automation's catalog have a degree of protection:
Ventilation
The ·with fan· option is only available on motors of the FXM family
·FXM5/FXM7 series· and of the FKM family ·FKM8 series and FKM66
models·.
Bearings
The bearings are closed on both sides and lubricated permanently. The
bearings should be replaced after working for about 20 000 hours or after
5 years.
Shaft extension
Seal
Meets the DIN 3760 standard.
FXM/FKM motors ·except FKM1/9 series· have the “seal” option both for
keyless shafts and for shafts with key. The seal is type BA and if the
standard degree of protection in the shaft is IP 64, i.e. fully protected
against dust and water splashes, an IP 65 degree of protection (meeting
the IEC 60034-5 standard) may be obtained with full protection against
dust and water jets.
F- 1/7
Mounting methods.
T- 1/4 Degrees of protection.
Motor model FXM
FKM2/4/6/8 FKM1/9
Configuration Degree of protection
Standard IP 64 IP 65
With a seal (option) IP 65 Irrelevant
With fan (option) IP 65 Irrelevant
T- 1/5 Shaft extension.
Motor family Cylindrical
shaft output
· with key ·
Cylindrical
shaft output
· keyless ·
FXM (in all its series) Standard Optional
FKM (in all its series) Optional Standard
Note. FAGOR does not supply the seal as a spare part.
IM B5
IM V3
IM V1
IEC 60034-7, code I
INFORMATION.
FAGOR shall not held responsible for any damage caused to the motor if the
user has replaced the seal.
i