Fagor FKM1 Series, Руководство по установке

Страница: 26 / 174

   General concepts
1.
GENERAL CONC
E
PTS
In
sta
llatio
n
34
· 26 ·
Ref.2105
FXM|FKM
SERVOMOTOR
1.3 Installation
Mounting conditions
This section describes the precautions to be considered when installing a
motor.
The motor must be installed under the following conditions:
 Leave some room between the motor and the machine structure,
never less than 5 mm (0.1968 in) in order to avoid possible
electromagnetic disturbances and transmission of vibration.
 Install the motor in places where the environmental conditions
(temperature and humidity) are the ones indicated in the general
characteristics table of each motor. Bear in mind that the motor must
be installed in clean and dry places, away f rom corrosive
environments and explosive gasses or liquids. If the motor is going to
be subject to oil and coolant splashes, it must be protected with a
cover.
 Make it easier to access for inspection and maintenance.
 Ensure free air circulation around the motor and the best possible way
for the air to go in and out for the fan (only optional on FXM5/7,
FKM66 and FKM8 series).
 Secure the motor mounting base, attached to a flat, robust and solid
surface. If the motor withstands excessive vibration, it may be
because the base it supports it is too weak or the coupling elements or
the machine are not balanced properly or it has not been aligned
properly.
 Fasten the motor with the right size of self-locking bolts, nuts and
washers of the right size and make sure that the tools used to fasten
them neither interfere with the operation of the motor nor damage it.
Things to check before the start-up
Before the start-up, make sure that:
 The servomotor has not been damaged in transit or in storage.
 All the electrical connections (power and feedback) have been
properly made.
 These connections do not come loose easily.
 The protection devices of the motor are active.
 The motor is not locked up.
 There are no other dangerous items.
 The key (if there is one) will not shoot off when turning the shaft.
INFORMATION.
The flange and the motor's rotor shaft contain an anti-corrosive paint and
grease. Use a solvent to clean the flange, the shaft and the keyway (if it
has one) before installing the motor.
i
MANDATORY.
When plugging the connector to the base connector, it is very common to
position them “blindly”. Make sure not to apply axial force between the
base and the plug when doing it so as not to damage the pins of the base
connector.
WARNING: HEAT DANGER!
DO NOT TOUCH
the surface of the motor while running or shortly after it
stops because of the high temperature reached on its whole surface! If it
is easily accessible, even certain precautions must be taken to prevent
involuntary contacts.
Also avoid heat sensitive elements (cables, etc) from being in contact with
the motor surface to avoid damaging or destroying those items and
possible more dangerous side effects.