4 / SPECIAL INSTRUCTIONS, TROUBLESHOOTING
. Check the electrical connection.
. Check that the spark plugs are clean.
. Check that the burners are clean and correctly
assembled.
. If the hob is clamped to the work top, check that the
mounting brackets are not deformed.
. Check that the gaskets under the control knobs are not
coming out of their inserts.
This is normal. The ignition function is centralised and
controls all burners simultaneously.
. Ensure strong air currents are not present in the room.
. Check that the gas type being used corresponds to the
injectors installed (review the injector markings in the
“Changing the Gas Supply” chapter).
. Check that the burner power screws are correctly
adjusted (refer to the “Changing the Gas Supply”
chapter).
. Check the cleanliness of the burners and injectors
under the burners, the assembly of the burners, etc.
. Check that there is enough gas in the cylinder.
. Use small saucepans on the burners located closest to
the control knobs. Larger saucepans should be placed
on the largest burners, which are furthest from the
knobs. Saucepan must be correctly positioned in the
centre of the burner. Saucepans should not extend over
the control knobs.
21
EN
DURING USE
•
PROBLEM:
RESOLUTION:
•
Burner ignition:
No sparks appear when the
control knobs are pressed.
•
When pushing in a control
knob, sparks appear on all
burners simultaneously.
•
In reduced heat mode, the
burner goes out or the flames
remain high.
•
The flames look irregular or
uneven.
•
The control knobs become hot
during cooking.
