Fagor CO-500, Руководство по обслуживанию

Страница: 52 / 124

22/07/2019
51
SERVICE MANUAL
EVO FRONT LOADING DISHWASHER
default).
LS P 1 L A V A D O 5 7 ºC
LI
.
9.6.11. STAND-BY AND ENERGY-SAVING
o Stand-by : Whenever the machine is at rest, it is considered to be in “Stand-by Mode” in which the boiler
temperature is 5 ºC lower than the set temperature to save energy. The tank temperature in stand-by is the
same as the set temperature.
o Energy-saving : If the machine does not run a programme within 30 minutes, the dishwasher switches to
“Energy-saving Mode” , in which the boiler temperature is 10 ºC lower than the setting temperature to save
energy. The tank temperature is 5 ºC lower than the set temperature.
o When the machine is in either of these 2 modes, if the water level falls below PT2, fill to PT3 (to
compensate for water lost in evaporation)
9.6.12. WASHING PROGRAMMES
The 4 wash programmes (P1, P2, P3 and PGLASS) are selected by successively pressing SELEC . The display
indicates the messages corresponding to the programmes. Only L2 remains lit. The selected programme starts
when the user closes the door. Led L2 goes out and L3 lights up indicating that a programme is running. If the door
is opened, the programme goes to PAUSE . If the door is closed again the cycle continues from where it left off
before the pause to the end of the programme.
When a programmed cycle finishes, L3 goes off and L2 lights up, indicating the option to select or run a new
programme. The machine remains on stand-by with the message “ END WASH ” until the door is opened. When the
door is opened the message “END WASH” changes to the normal operating message, showing the wash
temperature and the programme run.
The last programme run is stored in the memory (shown on the left of the display). Therefore when the door is
closed, the last programme used is run (unless the user selects another programme by pressing SELEC ).
When the user presses SELECT , the display indicates which programme is being selected, and the sequences of
the table below are displayed for 5 seconds.
PROGRAMME
SELECTED
BUTTON
TO PRESS
LED
ON
MESSAGE DISPLAYED
P1: short programme P-SELEC x 1 L2
P 1 0 1 : 0 0
P2: medium programme P-SELEC x 2 L2
P 2 0 1 : 3 0
P3: long programme P-SELEC x 3 L2
P 3 0 2 : 0 0
PGLASS: Glass wash
programme
P-SELEC x 4 L2
P G L A S S 0 1 : 3 0
Cycle time
Tank temperature programmed in P1 Last programme run; after filling by
default P1