Fagor CNC 8070, Конфигурация оборудования

Страница: 251 / 276

Hardware configuration.
CNC 8070
OP-PANEL /
OP-PANEL+SPDL R
A
TE.
13.
Bus CAN
(CAN
fag
or/CANope
n protocols).
·251·
(R
EF
: 1911)
13.8.1 Identification of the modules at the bus.
Each one of the elements integrated into the CAN bus is identified by its address or node
number. The CNC must always occupy position "0" and the rest of the elements of the bus
will occupy consecutive positions starting with "1". The node address or number also sets
the priority of the group within the bus; the lower the number the higher the priority. We
recommend to set the priority of the groups as follows (from highest to lowest).
• The groups that have the feedback inputs.
• The groups that have analog inputs and outputs.
• The groups that have digital inputs and outputs.
• The keyboard and jog panel.
In order for any change in the identification of the module to take effect, the CNC must be
restarted and turn off/on the corresponding module; however, we recommend to change the
address while the modules and the CNC are off.
Configuring the address (node number).
Address (node) of the element within the bus (0-15).
Address (node) of the element within the bus (16-31).
With the ·4· switch of the DIP switch, the positions or elements integrated in the CAN bus
may be expanded up to 32.
Each one of the elements integrated into the CAN bus is
identified by the 16-position rotary switch (0-15) "Address"
(also referred to as "Node_Select").
DS ·4· Address (node) of the element.
off Positions 0-15 within the bus.
on Positions 16-31 within the bus.
ADDRESS 0 1 2 3 ··· 13 14 15
DS4 = 0 0 1 2 3 ··· 13 14 15
DS4 = 1 16 17 18 19 ··· 29 30 31
4
0F
E
D
C
B
A
9
8
7 6 5 3 2
1
ID4 = 0
ADDRESS = 2 ADDRESS = 18
ON
ID3
ID2
ID1
4
0F
E
D
C
B
A
9
8
7 6 5 3 2
1
ADDRESS = 2
ID4 = 1
ON
ID3
ID2
ID1
ADDRESS = 2