Fagor CNC 8058elite T, Руководство пользователя

Страница: 57 / 90

Probing (·T· model).
CNCelite
8058 8060
8065
CA
NNED CYCLES. ISO CODED PROGRAMMIN
G
.
3.
#PROBE 3. Part mea
su
ring
al
ong the ordi
nate axis.
ꞏ57ꞏ
R
EF
. 2106
3.3.2 Basic operation.
In the following description, the Z axis is the abscissa axis and the X axis is the ordinate axis.
1 Approach movement.
Rapid probe movement (G00) from the cycle calling point to the approach point. This
point is located in front of the point being measured, at a ꞏBꞏ distance from it.
This approach movement is made in two stages. It first moves along the Z axis and then
along the X axis.
2 Probing movement.
Probing movement along the X axis at the indicated feedrate (F) until the probe signal
is received. Once probing is over, the CNC will assume the actual position of the axes
when the probe signal is received as their theoretical position.
The maximum probing distance is ꞏ2Bꞏ. If once this distance has been reached, the CNC
has not yet received the probe signal, it will issue the relevant error code and stop the
movement of the axes.
3 Withdrawal movement.
Rapid probe movement (G00) from the probing point to the cycle calling point.
This withdrawal movement is made in two stages. It first moves along the X axis and then
along the Z axis.