Fagor ASTRA Series, Инструкция по эксплуатации

Страница: 12 / 70

e n g l i s h
10
1
2
1.1 Unpacking (1.1.1, 1.1.2 and 1.1.3). Remove
the bolts and the fi xing and blocking elements
used for transport.
1.2 Connection to the water mains (1.2.1, 1.2.2
and 1.2.3). If the washer-dryer has a hot water
intake, connect the hose with a red connector
to the hot water intake (1.2.4). Always use the
new hose supplied, removing any previously
used hoses.
1.3 Drain. IMPORTANT! Place the hose in
the drain in accordance with the measurements
shown on the drawing.
1.4 Levelling. Correctly level the washer-dryer to
prevent any noise or shifting. The recommended
procedure is as follows: 1. Position the rear
legs and fi x them in place (1.4.1); 2. Place the
washer-dryer in its fi nal location (1.4.2); 3. Posi-
tion the front legs and fi x them in place (1.4.3).
1.5 Electrical connection. Take the electrical data
on the reference plate into account.
1.6 Installation under a worktop. If you need
to remove the worktop to recess-mount the
washer-dryer, contact your dealer or the Techni-
cal Assistance Service.
Recess dimensions are 600x600x850.
Installation
Operation
2.1 Opening the loading door. Open the loading
door.
2.2 Detergent and additives. Sort items by colour,
soil and fabric type before loading the washer-dryer.
The detergent drawer has the following
compartments:
wash , prewash and
fabric softener (2.2.1).
All the washer-dryers are designed to use deter-
gent powder (2.2.2). All the washing machines
are designed to use powder detergent (2.2.2). If
you wish to use liquid detergent (2.2.3), you will
see a blue tab for this purpose in the wash com-
partment. Pull it outwards as far as it will go,
then release it. It will remain in vertical position
(2.2.4), this will prevent the liquid detergent from
running out. To use powder detergent again,
place the blue tab in horizontal position and
push it back as far as it will go to open the fl ap
(2.2.5).
Remember you must not exceed the MAX level
marked on the fabric softener compartment.
2.3 Switching on and selecting the wash and
dry programme. Select the was programme
(2.3.1) using the control panel, after consulting
the programme chart (page 12). To select the
drying time, press the drying button
(2.3.2).
You may select automatic or manual drying.
The fi rst time the drying button is pressed “aut”
(automatic drying) will appear on the display.
When you press the button again, a manual
drying time of 00 min will appear, increasing
according to the
mode the button is pressed in:
Mode 1 -> if you hold the button down
the drying time will increase in steps of 10
minutes (from 00 min to 170 min).
Mode 2 -> press and release the button the
time increases 1 minute each time the button
is pressed.
2.4 Selecting the spin speed. You may choose
a spin drying speed or cancel out spin drying
(2.4.1, 2.4.2). If you select Anti-crease
(2.4.3) the wash process will pause before the
fi nal spin and the clothes will be left submerged
in water Press to run the fi nal spin dry.
MAXIMUM SPIN SPEED OF THE
MACHINE (r.p.m)
AVERAGE RESIDUAL
DAMPNESS* (%)
COTON programmes
SYNTHETIC programmes
WOOL programmes
QUICK programme
600
80
80
100
100
800
71
70
90
90
1000
62
70
90
80
1200
53
70
90
80
1400
52
70
90
80
*Residual dampness: the degree of dampness of the
clothes on completion of the spin dry phase
The drying function times given below are
for guidance only and will vary depending on
the number and size of the garments and the
composition of the load. The maximum load
admitted is 5 kg.
Cotton
Fabric
Guide to drying times RPM
Load 1000 1400
Mixed
5 kg
3 kg
4 kg
2 kg
170 min.
140 min.
130 min.
90 min.
155 min.
120 min.
120 min.
80 min.
LOAD TYPE:
Bath towel
Bath towel
Trousers (adult)
Trousers (child)
Cotton shirt (adult)
Polyester cotton shirt
T-shirt
Pyjamas
Lingerie
Sheets
800 gr
400 gr
700 gr
400 gr
200 gr
150 gr
250 gr
300 gr
50 gr
600 gr
0
Identify your washer-dryer model ( “a”, “b” or “c” )
by comparing the control panel with the illustrations.
Identifi cation