Fagor 8055 M, Руководство по программированию

Страница: 350 / 482

·350·
Programming manual
CNC 8055
CNC 8055i
13.
HIGH-LEVEL LANGUAGE
PR
OGRAMMING
·M· & ·EN· M
ODELS
S
OFT
: V02.2
X
Va
riabl
es
13.2.6 Variables associated with work zones
Variables associated with work zones are read-only variables.
The values of the limits are given in the active units:
If G70, in inches (within ±3937.00787).
If G71, in millimeters (within ±99999.9999).
If rotary axis in degrees (within ±99999.9999).
The status of the work zones are defined according to the following code:
0 = Disabled.
1 = Enabled as no-entry zone.
2 = Enabled as no-exit zone.
Read-only variables
FZONE
It returns the status of work zone 1.
FZLO(X-C) FZUP(X-C)
Lower limit of zone 1 along the selected axis (X-C).
Upper limit of zone 1 along the selected axis (X-C).
SZONE SZLO(X-C) SZUP(X-C)
Status of work zone 2.
Lower limit of zone 2 along the selected axis (X-C).
Upper limit of zone 2 along the selected axis (X-C).
TZONE TZLO(X-C) TZUP(X-C)
Status of work zone 3.
Lower limit of zone 3 along the selected axis (X-C).
Upper limit of zone 3 along the selected axis (X-C).
FOZONE FOZLO(X-C) FOZUP(X-C)
Status of work zone 4.
Lower limit of zone 4 along the selected axis (X-C).
Upper limit of zone 4 along the selected axis (X-C).
FIZONE FIZLO(X-C) FIZUP(X-C)
Status of work zone 5.
Lower limit of zone 5 along the selected axis (X-C).
Upper limit of zone 5 along the selected axis (X-C).
(P100=FZONE) ; It assigns to parameter P100 the status of work zone 1.
(P101=FZOLOX) ; It assigns the lower limit of zone 1 to parameter P101.
(P102=FZUPZ) ; It assigns the upper limit of zone 1 to parameter P102.