Fagor 8055 M, Руководство по программированию

Страница: 318 / 482

·318·
Programming manual
CNC 8055
CNC 8055i
12.
PROBING
·M· & ·EN· M
ODELS
S
OFT
: V02.2
X
PROBE 7.
Cor
n
er and
an
gle measur
ing canned cycle.
12.9.2 Basic operation (measuring an inside corner)
1. Approach movement.
Movement of the probe in rapid (G00) from the point where the cycle is called to the approach
point, situated at a distance (B) from the first face to be probed.
The approaching movement is made in two stages:
·1· Movement in the main work plane.
·2· Movement along the longitudinal axis.
2. Probing movement.
Movement of the probe along the abscissa axis at the indicated feedrate (F), until the probe signal
is received.
The maximum probing distance is 2B. If the CNC does not receive the probe signal before
reaching moving this probing distance, it displays the relevant error message and stops the axes.
3. Withdrawal movement.
Rapid probe movement (G00) from the probing point to the first approach point.
4. Second probing movement.
Movement of the probe along the abscissa axis at the indicated feedrate (F), until the probe signal
is received.
The maximum probing distance is 2B. If the CNC does not receive the probe signal before
reaching moving this probing distance, it displays the relevant error message and stops the axes.
5. Withdrawal movement.
Movement of the probe in rapid (G00) from the second probing point to the first approach point
6. Second approach movement.
Rapid probe move (G00) from the first approach point to the second. It is at a distance (B) from
the previous one.
7. Third probing movement.
Movement of the probe along the abscissa axis at the indicated feedrate (F), until the probe signal
is received.
The maximum distance to be traveled in the probing movement is 3B; if, after travelling that
distance, the CNC does not receive the probe signal, it will display the corresponding error code
and stop the movement of the axes.
1
2
3
4
5
7
8
B
B
B
B
6
9