252
points without having to reenter names and pitches.
Delete measuring point
Select this menu item to delete particular measured values.
The Detector displays a table containing all of the available measuring points. A
measuring point that has already been measured is indicated in the menu with
the symbol .
Select the measuring points you would like to delete and confirm the delete
process with the Enter button
.
6.11 Free measurement
In addition to the planned route
measurements you can also use the Detector
to carry out what are known as free measurements. For CM, balancing,
amplitude/phase measurements and run up/coast down measurements, select
the
New measuring point
menu item.
Example
: You are in the process of taking a round of measurements. You
notice an unusual noise or unusually high temperature on a machine that
is not included in this round of measurements. You can use the
New
position
option to carry out an additional on-the-spot measurement.
In these situations measurement templates must be defined using the Trendline
- Software. The templates you create depend on your particular circumstances.
The procedure for creating and transferring measurement templates is described
in detail under "Create template
". If there isn't a template from the Trendline
software on your Detector, you can select a default template on the device.
The Detector displays all velocity values during the free
measurement. These values are in the units selected in the
Trendline software for the template b eing used. In the
Settings
menu you can also change almost all settings during the free
measurement.
Free CM measurement
Position the sensor at the desired measuring point.
112
109