HOW TO ERASE A TRANSM ITTER CODE FROM A RECEIVER
7
1
st
Sequence TW O buttons
2
nd
Sequence ONE button
3
rd
Sequence TW O buttons
4
th
Sequence ONE button
5
th
SequenceTW O buttons
10 sec. TIM E
STAND ALONE RADIO RECEIVER CARD
PLUG-IN RADIO RECEIVER CARD
THIS EXPLAINS HOW TO ERASE A TRANSM ITTER CODE FROM A RECEIVER.
ALTERNATING OPERATIONS ARE TO BE PERFORM ED IN A SEQUENCE W ITH THE
SAM E TRANSM ITTER. RECOM M ENDED DISTANCE FROM THE OPERATIVE RECEIVER
AND AERIAL IS 10 TO 20 M ETRES.
Operative sequence
Insert the jumper “ STRIP” as in position “ P1” (if not already pre-set)
1
st
Operation. Press tw o buttons on the transmitter simultaneously. Release the
buttons. Proceed to the 2
nd
operation.
2
nd
Operation. Press one button only (as in the picture), then release it and proceed
to the 3
rd
operation, ie. press again the tw o buttons simultaneously. In other w ords
you repeat the first tw o operations alternately 5 times in total, as in the picture. The
limit time betw een one operation and the other is 10 seconds.
SHOULD IT BE REQUIRED TO ERASE SEVERAL TRANSM ITTER CODES, THE ABOVE
SEQUENCE M UST BE PERFORM ED INDIVIDUALLY FOR EACH TRANSM ITTER.
SHOULD YOU FAIL TO COUNT THE OPERATIONS IN THE CORRECT SEQUENCE OR PRESS THE W RONG BUTTONS, YOU HAVE TO START FROM THE BEGINNING. WAIT ONE
M INUTE BEFORE REPEATING THE SEQUENCE. M AKE SURE THAT THE RECEIVER HAS VOLTAGE.
TRANSM ITTER Jubi• 433,
4 CHANNELS
TRANSM ITTER Jubi-Small• 433,
2 CHANNELS
“ STRIP“
JUM PER
AERIAL
CH
A
N
N
EL
1
24 V a.c.
POW ER SUPPLY
CH
A
N
N
EL
4
CH
A
N
N
EL
3
CH
A
N
N
EL
2
“ STRIP“
JUM PER