FaderMate Master Control Unit, Руководство по фитингам

Страница: 14 / 36

3.4 Cabling
It is expected that the MCU will usually be mounted in an equipment rack adjacent to the
console. It is necessary to pass two types of cable from the rear of the MCU to one of the
FCUs inside the console:

Master data interface cable (a 26 way ribbon cable of length 2 metres terminated at
both ends by DB25 connectors).

Power cable (a 2 core cable of length 2 metres and diameter ~6mm)
Figure 3.4.1 shows the master data interface cable.
Figure 3.4.1 – Master Data Interface Cable
It is important to consider the dimensions of the DB25 connectors on the data interface
cable as one of these must also be passed into the console. The dimensions of the DB25
connectors are shown in Figure 3.4.2.
14