18
0
200mm x M10
threaded rod
anchor resin fixed
into
Ø14
mm hole
M10 S/S
cap nut
2
0
900x300x200mm
pad in C20 concrete
(recommended)
Ground
level
730
460 m
a
x
s
eat h
e
ig
h
t
1050 (Ctrs)
575 Ctrs
1050 (Ctrs)
900
2
0
0
163
163
150
150
300
2145 OVERALL
705
300
750
300
750
Foundation 3 no. pads
900x300x200mm
in C20 concrete
(recommended)
Installation Instructions
ALL INSTALLATION WORKS TO BE CARRIED OUT BY COMPETENT PERSONNEL - INSTALL AS COMPLETE UNIT
Mantis seat
1. Install suitable foundation with top face at ground level.
2. Position seat in correct orientation with bases centrally on foundation pads;
then mark hole positions through fixing lugs on legs (5 no. holes in total).
3. Remove the bench; drill holes Ø14mm x 200mm deep.
4. Clear debris from holes.
5. Fill the holes to within approximately 35mm from the top with Hilti HY150
resin (or similar). Lift the seat (with threaded anchor rods/capnuts in place)
and carefully lower the anchors into the holes, leave for two hours before
using.
6. Using a torque wrench, tighten nuts and washers onto fixing lugs to 30Nm
to securely fasten the seat. (Check that seat remains level during fixing
process.
4
MANTIS
installation