Factory Cat Pilot 24'' EDGE, Руководство по эксплуатации, Страница: 19 / 41

PILOT-OP-EN - 19 -
ONE PASS SCRUBBING:
1. Turn ON ( ) machine Key Switch (A) .
2. Ensure machine is fully charged before operation
by checking the Battery Gauge (B) .
3. Lower the Squeegee by manually lowering
the the Squeegee Lever (C) .
4. Turn ON ( ) the Squeegee Vacuum by pressing
the Vacuum Motor Switch [Black] (D) .
5. Lower Scrubdeck head to the fl oor by
pressing the Scrubdeck Toggle Switch
[Yellow] forward on the Control Panel
(E) .
6. Press the Solution Flow Switch [Blue] (F) to turn ON (
) solution fl ow. Use the Flow Lever to regulate (J) .
7. Begin scrubbing by depressing the Foot Pedal
(G) slowly and then to the speed required.
8. Once the machine begins to move, watch
the Brush Amp Gauge (H) to ensure no
circuits are tripped. Operate in Green.
9. To operate the machine in reverse, simply switch
the Reverse switch [Red] (I) back towards the
rear of the machine. The reverse speed is set
to approximately 50% of the forward speed.
10. To stop the machine, release the Foot Pedal
and the machine will stop automatically (G) .
SCRUB ONLY:
1. Turn ON ( ) machine Key Switch (A) .
2. Ensure machine is fully charged before operation
by checking the Battery Gauge (B) .
3. Lower Scrubdeck head to the fl oor by
pressing the Scrubdeck Toggle Switch
[Yellow forward on the Control Panel
(E) .
4. Press the Solution Flow Switch [Blue] (F) to turn on
solution fl ow. Use the Flow Lever to regulate (J) .
5. Begin scrubbing by depressing the Foot Pedal
(G) slowly and then to the speed required.
6. Once the machine begins to move, watch
the Brush Amp Gauge (H) to ensure no
circuits are tripped. Operate in Green.
7. To stop the machine, release the Foot Pedal
and the machine will stop automatically (G) .
VACUUM ONLY:
1. Turn ON ( ) machine Key Switch (A) .
2. Ensure machine is fully charged before operation
by checking the Battery Gauge (B) .
3. Lower the Squeegee by manually lowering
the the Squeegee Lever (C) .
4. Turn on the Squeegee Vacuum by pressing
the Vacuum Motor Switch [Yellow] (D) .
5. Begin squeegeeing by depressing the Foot Pedal
(G) slowly and then to the speed required.
6. To stop the machine, release the Foot Pedal
and the machine will stop automatically (G) .
ADJUST SOLUTION FLOW:
1. Push forward on the Solution Flow Lever (J) to
increase the solution fl ow and pull backwards on the
toggle to decrease solution fl ow
(SEE BELOW) .
H
D
I
F
E
A
B
G
C
J