Factory Cat Mag-HD V2.0, Руководство по эксплуатации

Страница: 34 / 54

- 34 - FC- WALK-BEHIND-V2 -OP-EN
PM SHEET
RPS Corporation © 202 1
CUSTOMER & MACHINE INFORMATION
Customer: Email:
Address: Phone:
City: State: Zip: Contact:
Serial #: Model #: Work Order #:
NOTE: Start with Machine filled at least with ½ Tank of water. Turn ON Machine and Test Functionality of Machine
CHECK OPERATION & CONDITION OF IN SPEC REPAIR PROBLEM
Key Switch
Battery Gauge
Deck Up / Down – Brush Switch
Brush Pr/- Toggle (Optional)
Vacuum Switch - ON / OFF
Squeegee Lever - Up/Down
Solution Switch - ON/OFF
Solution Flow Lever +/-
Green Drive Buttons - L & R
Reverse Toggle Switch
E-Stop (Optional)
NOTE: Drain Solution & Recovery Tank fully. Rinse out Recovery Tank
CLEAN & INSPECT – SOLUTION TANK IN SPEC REPAIR PROBLEM
Solution Fill Screen - Mesh
Solution Fill Hose (Optional)
Solution Inline Filter
Vacuum Muffler Drain Hose
Battery Drain Hose
BRUSH CONDITION – SCRUB DECK
Deck Curtains/Wipers Good Worn Needs Replacement
Brush Sockets: (2-Disk)/(4-Cylindrical) Good Worn Needs Replacement
Brush Drivers: (2-Disk)/(4-Cylindrical) Good Worn Needs Replacement
Scrub Brush Fiber Length Brush 1 Length: Brush 2 Length: Rotated Brushes: Y / N
CLEAN & INSPECT – SCRUB DECK IN SPEC REPAIR PROBLEM
Scrub Deck Linkage Pivot Points
Scrub Deck Lift Actuator
Scrub Deck Level (Orbital Only)
Scrub Motor Wires
CLEAN & INSPECT - SQUEEGEE IN SPEC REPAIR PROBLEM
Remove and Wipe off Squeegee
Check and Rotate Blades as Needed
Caster Wheels and Height
Pitch Adjust
Check Pivot and Knobs
Squeegee Vac Hose
CLEAN & INSPECT – RECOVERY TANK IN SPEC REPAIR PROBLEM
Recovery Tank Lid & Gasket
Vacuum Float Ball Screen
Vacuum Box White Filter
solution Site Tube
CLEAN & INSPECT – DRIVE IN SPEC REPAIR PROBLEM
Drive Wheels & Casters Condition
Grease Caster Swivel