Carefully check the crate for any signs of
damage. Check the crate to ensure that all
accessories are included. Batteries are in
the unit. The squeegee, brushes, and other
items are in the crate.
To uncrate the machine, remove banding
from around the crate. Take off the top and
sides and dispose of properly. Remove
banding from machine. Remove the chocks
around the drive wheels. Fold down ramp,
and roll machine off of the base.
NOTIFY THE CARRIER IMMEDIATELY IF
CONCEALED DAMAGE IS DISCOVERED.
Your machine is equipped with (4) 6 volt,
deep cycle, 395 amp hour batteries, which
form a 24 volt system.
CONNECTING BATTERIES
1.
2.
3.
4.
MACHINE PREP
Lower the squeegee mounting plate by
releasing the lever.
(See Fig. 2)
Loosen the two wingnuts on the
squeegee and slide them into the slots
in the squeegee mounting plate. The
squeegee trail wheels should face
outward.
Tighten the two wingnuts, and connect
vacuum hose from the machine to the
squeegee.
(See Fig. 3)
You may need to adjust the squeegee
pitch, by using the pitch adjustment
knob.
ATTACHING SQUEEGEE
MACHINE SETUP
UNCRATING MACHINE
1. Turn all switches to the OFF position.
2. Hinge open the rear compartment lid
to access the batteries.
3. All four cables should be tightly connected
to the batteries. Locate any loose one's
and tighten. This require's a 9/16" wrench.
Do not leave connection loose. Loose
connections burn cable.
(See Fig. 1)
4. Turn on main power switch and check the
battery condition meter to ensure correct
installation. Charge batteries if needed.
(See BATTERY CHARGING)
Fig. 3
Fig. 1
Fig. 2
PAGE 9