www.factorybuysdirect.com
200254-01A
8
INSTALLATION
Figure 4 - Connecting Gas to Appliance
Figure 5 - Vermiculite
Figure 6 - Glass support
Figure 7 - Glass Gems (Sold Separately)
Burner Pan Assembly
(Facing Front of
Fireplace)
Adapter Fitting
Gas
Connector
Tube
5. Using thread sealant (resistant to the ac
-
tion of natural gas) on larger end of fitting,
screw the burner inlet fitting through hole
and into burner manifold. Tighten using a
wrench.
6. Using burner clamp, screw, and nut pro
-
vided, assemble clamp to pan. This will
hold the burner manifold in place.
7. Using screws removed in step 2, install
cover plate over opening on right side of
burner pan.
8. If using optional control system kit, follow
instructions included with kit for installa
-
tion and operation.
Installation and Gas Connection
1. Place the burner pan assembly in the
center of the fireplace floor. Make sure
the front of pan faces forward.
2. Thread the gas supply fitting to the fire
-
place gas supply pipe. Use thread sealant.
3. Install adapter fitting onto the burner inlet
fitting using thread sealant on male threads
of burner inlet fitting (see Figure 4).
4. Install the gas connector tube to the gas
supply fitting. Carefully shape tube to at
-
tach to adapter fitting.
Installing Glass Burner Set
1. Fill burner pan with vermiculite until they
just cover the burner tube (see Figure 5).
2. Place glass support on top of vermiculite,
starting in the front of the burner pan, then
lowering into the back edge (see Figure
6). The screen should rest on the bottom
of the burner pan floor. If it sits too high,
remove some of the vermiculite to ensure
a proper fit. Vermiculite should not be on
top of the screen.
3. Place glass gems over glass support
allowing them to spill over the edge of
the burner pan (see Figure 7). DO NOT
exceed 2" depth of glass.
Keep pilot
area clear of glass.
Glass gems are sold
separately.
CAUTION: Glass pieces may
have sharp edges. Use hand
protection such as gloves if
necessary.
