GETTING TO KNOW YOUR FAN
Figure 1 : Components of this fan.
Upon removing fan from the package, check to make sure all parts are complete.
ASSEMBLY
1. Place fan base on firm stable surface such as a table or counter top.
2. Discard the plastic sleeve from the shaft.
3. Secure the rear grille to the motor housing with the plastic nut. Turn clockwise to tighten.
4. Slide the blade onto the shaft pin, pushing it on until it is firmly in place.
5. Ensure latches on either side of the front grille are open. Place front and rear grille together and close the side latches.
If they do not fit securely together, repeat the procedure.
OPERATING INSTRUCTIONS
Place the fan on a safe flat surface where it cannot fall or be pulled by the cord. Plug fan into a 120V/60Hz outlet and
follow the operating instructions:
This fan is equipped with two fan speeds to allow for optimal air comfort.
0- Pressing
this
button
will power the fan OFF.
1- Pressing this button will power the fan ON at LOW speed setting.
2- Pressing this button will power the fan ON at HIGH speed setting.
This fan has two functions which will allow you to better customize your preferred air comfort as well as improve
the air circulation in the room:
OSCILLATION: To activate the oscillation function for widespread breeze distribution, simply press the oscillation knob
down (located on top of the fan’s motor housing). To turn off the oscillation function for a targeted breeze setting, pull the
oscillation pin up. Controlling the oscillation can be done while the fan is operating.
TILT: To tilt the fan head so that the breeze is targeted at an angle, steady the base of the fan with one hand and grip the
motor housing with another, carefully tilt the head of the fan until it reaches the desired angle. Be careful as to not tilt the
head back further than it is intended to go, doing so will damage the unit.
CAUTION: TO PREVENT ELECTRIC SHOCK, MATCH WIDE BLADE OF PLUG TO
WIDE SLOT AND FULLY INSERT.
6629023
FT-23E
3