5.
(
2008-2011 MODELS)
--
Locate the upper leaf spring
plate. Use a drill with a
13/16” drill bit and enlarge the
factory hole in the plate.
This is so the new center pin
nut will fit inside the plate.
SEE PHOTO BELOW
6.
Locate and install the rear lift blocks, the factory block
will be positioned on top of the new Fabtech block, with
the short center pin of both blocks facing down, to the
axle. The short end of the blocks should face to the front
of the vehicle. Using the supplied u-bolts, nuts, and
washers align axle, lift blocks, and springs and torque to
U-Bolts to 180 ft-lbs. SEE PHOTO BELOW
FT30284
Spacer
FT30275
Add-a-leaf
2012 - UP MODEL
UBOLT
CONFIGURATION SHOWN
BELOW
7.
Install Fabtech shock part number FTS7266 Performance
Shocks or FTS81005 Dirt Logic Shocks (not included)
with the factory hardware and torque bolts to 65ft-lbs.
8.
Locate the E-Brake Cable mount on the driver side spring
pack perch. Remove the bolt attaching it to the perch and
discard the hardware.
9.
Locate FT30166 E-Brake Cable Sleeve and attach
between the spring perch and E-brake Cable bracket
using the supplied 5/16”-18 x 2” bolt and split washer.
SEE PHOTO BELOW
20
08
-
2011
MODEL
UBOLT
CONFIGURATION
SHOWN BELOW
