Illustrations, clockwise from top left:
Universal end brackets, Coupling/Center bracket, End caps,
Installation screws and Bead chain stops.
- page
2
of
4
-
STEP 2 - INSTALLING THE SHADES
.
FOR THE MULTI LINK SYSTEM
a) Sort the shades by looking closely at the ends of the
shades. One of the shades will have a control end for the
lifting mechanism (either a MOTOR or CCO) on one side,
and a male coupler on the other.
The other shade will have an idler end on one side and
a female coupler on the other side. If using a three
shade application, one shade will have female coupler
on one end and a male coupler on the other end.
STEP 1 - INSTALLING THE BRACKETS.
Use a level to ensure a horizontal position. The end brackets
have a cross shaped hole and are universal. They can
be used on either side as well as for wall, ceiling or inside
installation. The coupling/center bracket(s) have a center hole.
The outside bracket to bracket should be 1
³⁄₈
” greater than
the sum of the cloth widths, plus
³⁄₈
” for each space.
Example: Cloth width for shades are 24” x 2 shades = 48” plus
³⁄₈
” for the space between the shades plus 1
³⁄₈
” for bracket
allowance = 49
³₄
” bracket to bracket.
BEFORE YOU BEGIN, VERIFY THAT YOU HAVE ALL THE NECESSARY
PARTS AND PIECES:
• PACKAGE -
Contains two universal end brackets with a
cross shaped hole, center brackets (one only for the Duo
Link application, one or two for the Multi Link, depending
on the application), two end caps, two to four bead chain
stops, and six to eight installation screws.
Female coupler end
with
flat sides
Male coupler end
with
flat
sides
STEP 2 - INSTALLING THE SHADES
(CONTINUED)
.
FOR THE MULTI LINK SYSTEM
Note: On the shade with the idler end, remove the
transit clip. Save this clip as it will be reinstalled once the
installation is complete.
b) Begin by installing the first shade with the control end. The
control end of this shade must be installed first. Gently
slide the bracket pin into the middle of the cross shaped
hole of the end bracket, and pull down to lock in place.
c) Then depress the male coupler end in order to slide into
the center hole of the coupling bracket.
Note: This coupler has two flat sides.
Transit Clip
Male coupler end with flat sides
Inserted male coupler end
