Faber Respect Premium OC, Руководство по установке

Страница: 13 / 32

Installation manual Respect Premium OC
13 < < < <
5.3 Placing the sealing cord

Start on the right-hand side in the upper
right-hand corner and push the sealing
cord into the glass clips (see fig. 3.6a) at
the points indicated in the glass grooves
(see fig. 3.6b to 3.6d).

Place the vertical cover strips (fig. 4.0-A).

Place the horizontal cover strips (fig. 4.0-
B).

Please note!
Avoid fingerprints on the glass, these are no
longer removable once the fire is used.
6 Placing decoration material

Please note!

It is not permitted to use other or to add
more material in the combustion
chamber.

Do not throw the decoration material on
the burner at once. It is possible that the
burner gets clogged.
6.1 Log set
See the supplied decoration instruction card or
chapter 18.1:

Divide part of the ash material on the
burner and the bottom.

Place the log set.

Divide the rest of the ash material over
the burner and the bottom. Avoid a
double layer, this has a negative effect on
the fire.

Please note!
Keep the pilot flame and 2
nd
thermocouple
free from ash material!
Glow fiber
Glow fiber gives a decorative glow effect. Pull the
glow fiber apart and spread it between the logs on
the burner.

Please note!
Keep the pilot flame and 2
nd
thermocouple
free from glow fiber!

Start the fireplace as described in the user
manual.

Assess whether the flame distribution is
good. Move or remove any ash material
to create a nice glow bed.

Install the front glasses and check the fire
image.
6.2 Pebbles / Grey stones
See the supplied decoration instruction card or
chapter 18.2 or 18.3:
Divide the pebbles / grey stones over the entire
bottom. Avoid a double layer!

Please note!
Keep the pilot flame and 2
nd
thermocouple
free from pebbles / grey stones!

Start the fireplace as described in the user
manual.

Assess whether the flame distribution is
good. Move or remove any pebbles / grey
stones.

Install the front glasses and check the fire
image.
7 Checking the installation
Checking for gas leaks
Check with a gas leak finder all connections and
pipes for gas leakage.
Check primary- and burner pressure
Check if the primary pressure correspond to the
data on the rating plate.
Measuring the primary pressure:

Close the shutoff valve. Turn the
measuring nipple “A” (fig. 1.3) a few turns
to open and connect a measuring hose to
the gas valve.

Take this measurement when the
fireplace runs at high and low settings.

Do not use the device if the pressure
deviates (+20% and -20%).
Measuring the burner pressure:
Check the burner pressure only with proper
primary pressure.

Turn measuring nipple “B” (see fig. 1.3) a
few turns open and connect a measuring
hose to the gas valve.

The pressure must correspond to the
value indicated in the technical
specifications of this manual. In case of
deviation contact the manufacturer.

Please note!
Close both pressure measuring nipples and
check for gas leakage.