Faber Respect OC, Руководство по установке

Страница: 9 / 24

8 < < < <
L
Before proceeding with the installation of the
fire Install the side and front glass of the fire
to check the squareness (See chapter 6)
With a correct squareness of the unit, all
glass panel will match correctly to each other
Note: remove all glass panels after this check
and proceed the installation work.
4.6 Mounting the flue materials.

In case of a wall or roof terminal, the
hole must be at least 5 mm bigger
than the diameter of the flue
material.

Horizontal parts must be installed at a
(3 degree) slope up away the
appliance.

Build up the system from the
appliance. If this is not possible, you
should make use of a adjustable pipe

For fitting the system a ½ metre
cut-down pipe should be used. Make
sure the inner pipe is always 2 cm
longer than the outer pipe. Wall and
roof terminal are also shortened.
These parts must be secured with a
self-tapping screw.

Do not insulate but ventilate build-in
flue material (approx.100cm2)
4.7 Building a chimney breast.
Before constructing the chimney breast we
advise you to perform a function test with the
appliance as described in chapter 7 “checking
the installation”
4.8 Chimney breast

Construct the chimney breast from
non-combustible material in
combination with metal profiles or of
brickwork / aerated concrete bricks.

Take the grills and the service panel
into account. ( see fig. 1.1 and 1.2).
Place a protective shield made of
non-combustible material above the
grills (see fig 1.1 A) .

Always use a lintel if the chimney
breast is constructed of brickwork.
These should not rest onto the build-
in frame.

The chimney construction may not
resting on the build-in frame
5 Placing the decorative material
It is not allowed to add different or more
materials to the combustion chamber.
Always keep the pilot burner and the second
thermocouple free from decorative material!
(See fig. 4.1 A up to 4.3 A)
Do not toss all the decorative material onto
the burner all at once, it can be obstructed
by dust particles.
5.1 Imitation logs

Place a number of the chips onto the
burner and on the cover plate

Place the imitation logs according to
instructions. (see fig. 4.1 or imitation
logs instruction card supplied)

Divide the remainder of the chips
over the burner and the cover plate .
Avoid a thick layer onto the burner,
this has a negative effect on the fire
image.

Ignite the pilot and main burner
according to the instructions in the
user’s manual. Assess whether the
flame division is correct. If necessary,
move the chips until there is a proper
division of flames.

Place the glass and check the fire
image.
5.2 Pebbles / Grey stone

Place the pebbles over the burner and
the bottom. Spread the pebbles
evenly to a double layer. The surface
of the pebbles may be very slightly
elevated from the burner (see fig.4.2
and 4.3)

Place the glass and check the flame
picture into the appliance
6 Installation front and side glass
Take all glass part out the packing and use
the suction discs for placing the glass
, t
he
side glass need to be install first
Note: before placing the glass remove all
fingerprints on the glass, these will be burned
into it once the appliance is used.
6.1 Placing side glass

Slide the glass between the groove
and built-in frame (See fig.3.1)

(Next steps all in one move)
keep the glass tilted slightly to the
side (See fig.3.2).