Faber PEBBLES Series, Инструкция по эксплуатации, Страница: 5 / 9

5
1. All the plumbing works should be completed before proceeding
to electrical wiring connection.
2. INLET and OUTLET connection of the heater unit should not be
reversed, with stop valve installed on INLET. (Diagram 1)
3. It is recommended to mount the unit at 1.5mm above the
floor to bottom of the hater.
4. Mounting position (Refer Diagram 2)
• Remove screw from the bottom of the heater
• Lift the plastic cover upward
• Mark mounting position on the wall for all
4 screws
• Drill the holes with 5.0mm diameter drill bit
(Refer Diagram 3)
• Install the unit to the wall with plug
5 Installation of Heater INLET and OUTLET connection.
a) Connect the stop valve to INLET, and be sure to put a
gasket to prevent water leakage.
b) Connect the pipe from the stop valve to incoming
water supply. If necessary make use of sealing tape
for the connection to prevent water leakage.
c) Connect flexible hose to heater OUTLET. Turn on
the water mains to drain out all the plumbing dirt
and fill up the heater tank. Then, connect the
flexible hose to the hand shower.
(Note: This step will prevent damage to the heating element).
3. INSTALLATION PROCEDURES
Floor
Stop Valve
1.5m
Diagram 1
Diagram 2
Diagram 3
SAFETY PRECAUTION
Do not install reverse INLET and OUTLET of heater
INLET
OUTLET
OUTLET
OUTLET
correct installation inlet - outlet reverse
(wrong installation) stop valve reverse
(wrong installation)
INLET
Lift upward