Faber Matrix FMG3326F, Инструкция по эксплуатации

Страница: 73 / 78

73 FaberFires.com
Unit does not power on using the remote control
Remote control is not synced
Remote must learn new code
Press and hold the receiver’s reset button until you hear 2
release the reset button and within the subsequent 20
handset until you hear an additional long acoustic signal
• if 15-20 seconds pass while pressing and holding
Remote batteries are dead
Receiver batteries are dead
Pins on the 8-pin connector are bent
Inspect the pins and straighten as needed
Receiver is surrounded by metal - transmission range is
reduced Bring remote closer to receiver
RF interference - transmission range is reduced Change the position of the antenna
Receiver is defective Replace receiver
Remote is defective
Ensure labels on back of remote and receiver match in
Replace remote if needed and reprogram code.
No ignition, no tone
Remote and receiver are not synced See above to ensure remote has correct code to receiver.
Receiver has no power Check power to receiver.
Receiver is defective Replace receiver
No Ignition; One continuous 5 second tone (7 short beeps might be heard prior to the 5 second tone)
Loose wire
Bent pins on 8 wire connectors
Receiver requires power cycling
Reset receiver and resync remote
Receiver is defective Replace receiver
Valve is defective Replace valve
No Pilot Flame and control continues to spark
Air in the pilot line.