Faber MatriX 800/500 I 2, Руководство по установке

Страница: 11 / 44

Installation manual MatriX 800/500 I,II,III 2 and MatriX 800/650 I,II,III 2
11 < < < <
4 Preparation and installation
instructions
4.1 Gas connection
The gas connection must comply with the
applicable local standards.

Please note!
Calculate the gas pipe so that no pressure drop
occurs.
We advise using a gas connection directly from the
gas meter to the appliance, with a shut-off valve in
the proximity of the appliance, which must always
be freely accessible. Position the gas connection so
that it is easily accessible for service and the burner
unit can be disassembled at any time.
4.2 Electrical connection
Install a 230VAC/50Hz wall socket near the fireplace
for connecting the Control box FAB1806.
See fig. 2.8 for the wiring diagram:
A = I.T.C. (Intelligent Technical Controller)
B = electronics
C = gas valve
D = solenoid valve
E = Symbio LED module (optional)
F = ignition pin
G = ionization pin
H = power cable
I = configuration plug
4.3 Smart Home installation
The controller can be connected to an external
source, such as a Domotica system, by using a Faber
Interface Unit (article number A9323000).
4.4 Preparing the fireplace

Remove the fireplace from its packaging.
Ensure that the gas supply pipes under the
appliance are not damaged.

Prepare the gas connection on the
regulator. Provide a flexible gas connection
with at least 0,5m extra length, so that the
control unit can be removed for
installation and service!
4.5 Positioning the fireplace
Take into account the installation requirements (see
chapter 3). Place the fireplace at the right place and
level it.
Rough height adjustment:

With the adjustable (optional) legs.
Accurate height adjustment:

With the adjustable feet.
Hanging on the wall
The fireplace can also be mounted on the wall by
using the optional wall bracket set, see attachment
16.9 (article number A9325896).
Therefore remove the existing brackets and use the
supplied spacer for vertical alignment, see fig. 1.4.
4.6 Installing the flue pipes
Install the flue pipes according to the installation
manual supplied with the appliance! (40011968)

The distance to combustible materials
must be min. 50mm, calculated from the
outside of the flue pipe.

Never start immediately with length-
adjustable concentric flue pipe on the
appliance.

Horizontal sections should be installed to
allow a slope towards the appliance
(3 degrees).

Build the system from the appliance. If this
is not possible you can make use of an
extendable adapter section.

For fitting of the flue system, the 0,5m
length-adjustable pipe must be used. Make
sure that the inner pipe is always 15mm
longer than the outer pipe. Wall- and roof
terminal can also be cut. These
components must be secured with a self-
tapping screw.
4.7 Constructing the false chimney
Before positioning the false chimney, we advise to
perform a functional test with the fireplace as
defined in chapter 7 “Checking the installation”.
False chimney

Construct the false chimney of non-
combustible material in combination with
metal profiles or of masonry/concrete
blocks.

Always use a lintel or reinforcing bars while
bricking the false chimney. They should not
be placed directly on the fireplace.

Make sure that the fireplace never
functions as a load-bearing construction,
because of the expansion of the fireplace
through warmth.