Version 03/15- Page 9
INSTALLATION CONTINUED
Optional Duct Cover Installation
1. Attach the full-width duct cover to the top of the range hood
with the screws provided. The duct cover must be attached
to the top of the range hood before mounting the range hood
to the wall.
A: Distance from center of mounting bracket to centerline:
30" hood: 13 15/32" / 36" hood: 16 15/32" /
42" hood: 19 15/32" / 48" hood: 22 15/32"
B: Mounting brackets
C: Top of hood
2. Install each bracket on the wall as shown. Make sure the
screws and brackets are securely fastened to the wall.
IMPORTANT: Install only the brackets. Do not install the
hood.
Optional Telescopic Chimney Extension Installation
1. If a chimney extension is used, attach the extension brackets
as shown. Make sure that the screws are securely fastened to
the wall.
A: Ceiling
B: Brackets
C. Top of hood
Complete Preparation
1. Determine and make all necessary cuts in the wall for the vent
system. Install the vent system before installing the range
hood.
2. Determine the location where the power supply cable will be
run through the wall.
3. Drill a 1¹⁄₄" (3.2 cm) hole at this location.
4. Pull enough power supply cable through the wall to allow for
easy connection to the terminal box.
5. If roof or wall cap does not have a damper, attach damper to
exhaust opening(s) on top of the hood using two Phillipshead
screws.
6. If 48" (121.9 cm) hood is to be connected to 10" (25.4 cm)
round vent system, install the vent transition piece now.
Install the Range Hood
2. Connect vent system to hood. Seal all joints with clamps.
3. If your installation uses the optional duct cover, fit the cover
flanges over the brackets. If installation uses the telescopic chimney
extension, fit the extension over the brackets. Install the upper section
first, then fit the lower section over the upper section. Seal extension
to hood with clamps
The hood attaches to the wall by screws discussed in the
“Mounting Screws Installation” section.
1. Using 2 or more people, hang the range hood on the two
mounting brackets and adjust the mounting brackets from inside the
hood to make the hood level.
IMPORTANT: Make sure that the range hood is securely
tightened against the wall.
