UK/IRL
>
>
>
>
45
2)
Continue to hold in the control knob for a further ten seconds to
ensure that the pilot flame is stable.
3)
Release the knob. The pilot should remain alight.
4)
Turn the control knob A to the position.
5)
Set the on/off switch on the receiver to "on”.
-
low flame
-
high flame
6)
Use the and buttons to achieve the desired heating and flame
effect.
7)
You will hear a beep every time the receiver recognises a good signal.
(If not, so see 10.4.3, setting the right transmission code).
8)
When the fire is not be used for a prolonged period, turn off the pilot
(see 10.4.2)
11.4.2
To extinguish
1)
Push (low) till the burner goes out and you can hear the motor
clicking.
2)
To enable the remote control turn knob A to the
position.
3)
To extinguish the pilot turn control knob A to position , although it is
in order to leave the pilot permanently lit.
11.4.3
Setting the right transmission code
The receiver has to learn the code from the transmitter, which is already
done at the factory. However the code disappears if the receiver is
disconnected from the mains for a longer period.
1)
Set the on/off switch on the receiver to "on".
2)
Push the "mod" button on the receiver and hold it for 3 seconds.
3)
The green control lamp will light up and stay on. Repeat this step if it
doesn't.
Содержание Ease (BF100H)
Страница 2: ...UK IRL 2 ...
Страница 39: ...UK IRL 39 User Manual ...
