Faber Duet L Smart, Руководство по установке

Страница: 12 / 44

Installation manual Duet M,L Smart
11 < < < <
must be installed just above the ventilation
openings. (see fig. 1.5-A and 1.6-A).
Installation and finishing

Please note!

Take into account a minimum distance of
2mm due to expansion of the fireplace.

Take into account the thickness of any
finishing layer!

Check during installation whether the
glass can still be installed.
Method I – cover strip (fig. 2.0a)

See fig. 2.1, build the false chimney
against:
o
Distance profiles A;
o
Build-in frame D;
o
Build-in supports C.

The top of distance profiles A must have
the same height as point E.

Before placing the cover strips, remove
the build-in supports C.
Method II – p cover strip (fig. 2.0b)

Please note
After installation, the top of the plateau must
have the same height as point E, see fig. 2.1.

See fig. 2.1, remove the distance profiles
A. To ensure the air tightness of the
appliance, replace the screws!

Build the false chimney against:
o
Build-in frame D;
o
Build-in supports C.

Build the plateau against distance holders
B;

Before placing the cover strips, remove
the build-in supports C.
Method III – p insert strip (fig. 2.0c)

Please note
After installation, the top of the plateau
should be 4mm higher as point E, see fig. 2.1.
Perform the steps of Method II.
Placing the cover strips / insert strip

Place the horizontal cover strip Q (fig. 3.0)
or the horizontal insert strip R (fig. 3.1).

Place the vertical cover strips S (fig. 3.2).
these are held in place by adjustable
magnets.
The insert strip R can be removed by the supplied
magnet T (see fig. 3.1).
5 Removing glass
5.1 Front glass

Remove the horizontal cover strip (fig.
3.0) Q or the horizontal insert strip R (fig.
3.1). The insert strip R can be removed by
the supplied magnet T (see fig. 3.1).

Place the suction cups on the glass (fig.
4.0).

Remove the glass sealing cord (fig. 4.1).

Carefully lift the glass and pull the
underside towards you (fig. 4.2).
For replacing the glass repeat the steps in reverse
order.

Please note!
Avoid fingerprints on the glass, these are no
longer removable once the fire is used.
5.2 Side glass
For cleaning only it’s not necessary to remove the
side glass.

First remove the front glass. (see chapter
5.1).

Remove the log set, bottom plate and
burner (fig. 4.3).

Place the suction cups on the glass (fig
4.0).

Remove the glass sealing cord.

In this position, slide the glass forward.
Lift the glass slightly and push the bottom
into the appliance (fig. 4.4).
For replacing the glass repeat the steps in reverse
order.

Please note!
Avoid fingerprints on the glass, these are no
longer removable once the fire is used.