Faber Blokhus, Руководство по установке

Страница: 10 / 36

Installation manual Blokhus (Extension modules & HE-module)
9 < < < <
5 Removing glass
5.1 Front glass

Remove the front panel. This is possible
by slightly lifting the panel and pulling the
bottom towards you (fig. 1.1 and 1.2).

Remove all glass clamps (fig. 1.3).

Remove the front glass. (fig. 1.4).
For replacing the glass repeat the steps in reverse
order.

Please note!
Avoid fingerprints on the glass, these are no
longer removable once the fire is used.
5.2 Side glass
For cleaning only it’s not necessary to remove the
side glass.

Remove the front glass (see chapter 5.1);

Remove the log set;

Remove the 2 log set supports (fig. 2.1);

Remove the burner plate (fig. 2.2);

Place a suction cup;

Remove the 4 glass clamps (fig. 2.3);

Remove the side glass (fig. 2.4).
For replacing the glass repeat the steps in reverse
order.

Please note!
Avoid fingerprints on the glass, these are no
longer removable once the fire is used.
6 Placing decoration material
It is not permitted to use other or to add more
material in the combustion chamber.
See the supplied decoration instruction card in
chapter 18:

Place the glass panel (fig. 2.0 F) on the
bottom in the gaps left and right.

Spread the glass granulate over the glass
panel (one layer) and cover these with
part of the supplied vermiculite granules
(the amount of vermiculite granules
affects the intensity of the glow effect and
can be done according to your own
discretion);

Place the log set. Make sure that the logs
are properly connected to the tube
burners and rest on the bottom of the
fire. Remove the glass granulate and
vermiculite granules underneath these
logs.

Divide the ash material between the logs,
don’t cover the air intake (the perforated
parts at the back).

Please note!
Keep the pilot flame free from glass granulate
and ash material!

Start the fireplace as described in the user
manual.

Assess whether the flame distribution and
if present, the Symbio effect (glow bed), is
good. Move or remove any glass granulate
/ ash material to create a nice glow bed.

Install the front glass and check the fire
image.
7 Checking the installation
Checking for gas leaks
Check with a gas leak finder all connections and
pipes for gas leakage.
Check primary- and burner pressure
Check if the inlet pressure correspond to the data
on the rating plate.
Measuring the inlet pressure:

Close the shutoff valve. Turn the
measuring nipple “A” (fig. 1.7) a few turns
to open and connect a measuring hose to
the gas valve.

Take this measurement when the
fireplace runs at high and low settings.

Do not use the device if the inlet pressure
deviates (+20% or -20%).

Measuring the burner pressure:
Check the burner pressure only with proper inlet
pressure.

Turn measuring nipple “B” (fig. 1.7) some
turns open and connect a measuring hose
to the gas valve.

The pressure must correspond to the
value indicated in the technical
specifications of this manual. In case of
deviation contact the manufacturer.


Please note!
Close both pressure measuring nipples and
check for gas leakage.
Check ignition and burner
Ignite the fireplace by using the remote control as
described in the user manual and test all burner
possibilities.