CONFIGURATION SYSTEM
Configuration water preheating (Plug + T3 activation - T1 T3 ICO1 ICO3 config.)
Insert the plug into the socket while pressing the key T3
After about 1 sec. ICO1 and ICO3 alternately flash quickly to indicate the activation of the
configuration
Release T3
ICO1 flashing function disabled
ICO2 flashing function activated
Press T3 to define the ON / OFF of the function, press T1 to save the setting
Wait for 5 seconds without pressing any buttons to exit the configuration.
Configuration output in “Heating”
Configuration Reset factory parameters
(activation of Plug + T1 + T3 - config. T1 T3 ICO1 ICO3)
Insert the plug into the socket while holding down the buttons T1 and T3.
After about 1 sec. ICO1 and ICO3 quickly flashes ICO1 and then ICO3
Release T1 and T3
Reset to factory parameters (Plug Acti T1 + T3)
The following parameters are reset to default values:
Duration of T1 and T3 supplies Preheating: enabled
2.
3.
1.
1.
2.
3.
4.
5.
6.
7.
8.
(T1 o T3)
Interruttore accensione ON/OFF
Factory Default
VALUES DURATION COFFEE BREWING
The new duration is saved only if superior to 10 seconds.
Programmable by user
T1 - Brewing short coffee
T3 - Brewing long coffee
24 seconds
33 seconds
Minimum 10 sec./Maximum 75 sec.
Minimum 10 sec./Maximum 75 sec
T1
T2
14
