22. With assistance, hold the bumper up to
the mounts and use a 5/8” socket wrench
to install the three 7/16”-1” zinc steel hex
bolts with flat and lock washers to the wing
mounts (50199-HW). Repeat step on the
other side of the truck. (Figure-23)
23. Use a 5/8” and 11/16” socket wrench
to install the three 7/16”-1.5” zinc steel hex
bolts with flat and lock washers and nuts
(50199-HW) repeat step on the other side of
the truck. (Figure-24)
Figure 23
Figure 24
24. Adjust the bumper and wings to desired
position then fully tighten all mounting
bolts on the bumper and brackets. It is
important to double check every bolt to
make sure it is fully tightened.
