11
11. Loosely install the remaining six (6)
stainless steel button head bolts in the
center crossbar to the front tube assembly
using a 3/16” allen wrench and 1/2”
socket wrench (50211-HW). Aline the tube
assemblies so that all faces are flush, then
use a 9/16” socket wrench to fully tighten
the 3/8” hardware installed in step 8.
Repeat on opposite side. Figure 11.
12. Use a 1/2” socket wrench to attach the
tube assembly to the front support arms
using a 5/16” yellow zinc hex head bolt with
flat/lock washers and nuts (50211-HW).
Figure 12.
Figure11
Figure 12
13. Loosely install the front visor using
six (6) 5/16” button head bolts with flat/
lock washers and nuts from the JTOR-01
hardware kit using a 3/16” allen wrench and
1/2” socket wrench (50190-HW). Figure 13.
Figure 13
